Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Smoke & Mirrors

CM 3.3.3sr4a

I have a group of telephones which according to CM are loaded with a set of numbers that differe from the ones on the sets themselves. eg. CM says line 2 on set "A" is blank, not assigned, but looking at Set "A", it says line two is 1234, it id's as 1234, it can make and receive calls as 1234. Resetting the phone doesn't clear the appearance. Now what???

3 REPLIES
Super Bronze

Re: Smoke & Mirrors

Hi

Sounds like your phone may be registered to a subscriber that has replication issues with the config db...

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00801e7ddf.shtml

Regards

Aaron

Please rate helpful posts...

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
New Member

Re: Smoke & Mirrors

Thanks,

We just rebooted all of the Call Manager servers and the "problem" went away. (The servers had been in operation for over 30 days)

Lee

New Member

Re: Smoke & Mirrors

Aron your Post deserve a Rating. The Link also was very knowledgable.

Thanks on behalf of Lee

M.Tag

89
Views
9
Helpful
3
Replies