Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

snmp traps with Call Manager 4.13

Anyone being able to get snmp traps from Call Manager 4.13 to work. I can walk the MIB and get snmp cold start traps but no Call Manager specific traps

2 REPLIES
Silver

Re: snmp traps with Call Manager 4.13

There is a possibility that the CCM service controls this trap and thus cannot send a trap until it is up. This is an issue seen in many devices not just CCM. CCM supports only certain traps.Refer the following URL for more information

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803f52e1.html#wp1041935

New Member

Re: snmp traps with Call Manager 4.13

We're in the same boat. A customer of ours has CCM 4.0.2 and 4.1.3...they're unable to send CCM-specific SNMP traps to our application. They configured Windows 2000 to send traps to the SNMP Manager server's IP address and they defined a READ-WRITE community as descrived in the CCM SNMP setup doc. Is there any other things left to do? Any editting need to be done on the CISCO-CCM-MIB file? Thanks.

249
Views
0
Helpful
2
Replies