Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SNMP with 6608 blade ?

Are there any SNMP MIBs for the 6608 blade ? For example I was to see if port 7/1 is "registered" ? I did a SNMPWALK on a 6509 with a 6608 blade and could not find anything under CatOS 5.5(11) relating to 6608 port status.

Or perhaps I can do a SNMPGET against the CallManager to see if a conference bridge is registered ?

I hate to setup Perfmon for alerts, etc when I have OpenView, etc.

  • Other Collaboration Voice and Video Subjects
2 REPLIES
Bronze

Re: SNMP with 6608 blade ?

All of Cisco’s published MIB’s are here: '

http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml

But at a glance, I didn’t see one.

New Member

Re: SNMP with 6608 blade ?

There is a MIB for CallManager CISCO-CCM-MIB-V1SMI.my but I didn't see someway to determine a CCM server has conference resources available (altough I'm not very good at reading raw MIBs).

I'd rather manage my voice network with OpenView (SNMP)/Cisco Voice Health than Perfmon!

ftp://ftp.cisco.com/pub/mibs/v1/CISCO-CCM-MIB-V1SMI.my

I've opened a case with TAC, but as usual my knowledge is past theirs, so they are researching it. I was hoping a CCM developer was reading this group!

119
Views
0
Helpful
2
Replies
This widget could not be displayed.