11-22-2001 06:21 PM - edited 03-12-2019 01:28 PM
Are there any SNMP MIBs for the 6608 blade ? For example I was to see if port 7/1 is "registered" ? I did a SNMPWALK on a 6509 with a 6608 blade and could not find anything under CatOS 5.5(11) relating to 6608 port status.
Or perhaps I can do a SNMPGET against the CallManager to see if a conference bridge is registered ?
I hate to setup Perfmon for alerts, etc when I have OpenView, etc.
11-29-2001 01:27 PM
All of Ciscos published MIBs are here: '
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml
But at a glance, I didnt see one.
11-29-2001 02:30 PM
There is a MIB for CallManager CISCO-CCM-MIB-V1SMI.my but I didn't see someway to determine a CCM server has conference resources available (altough I'm not very good at reading raw MIBs).
I'd rather manage my voice network with OpenView (SNMP)/Cisco Voice Health than Perfmon!
ftp://ftp.cisco.com/pub/mibs/v1/CISCO-CCM-MIB-V1SMI.my
I've opened a case with TAC, but as usual my knowledge is past theirs, so they are researching it. I was hoping a CCM developer was reading this group!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide