I am trying to integrate the sopthone w/ our corp directory . I am wondering, on the directory service page on the softphone client, in the server name box, do you use the ip address of CCM listing on port 8404. Or do you input the LDAP server ip address. If the LDAP server is to be used then what is the default port to listen in on what should you put into the search base field.
I have used the IP address of ldap server and fully quailfied name with no results. In the search base how far should you go down the directory tree? Also what order should they be in, If anyone has an example outside of what is avialble on online documentaion would be very helpful.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...