Does anyone have any feedback on software that will monitor channels on a pri line on a router. The Admin. Serviceability Tool under Devices will not allow me to see individual channels for a H323 device. I asked Cisco Tac and they agreed that it was not possible at this point. I dont want to telnet to each gateway and do line commands for this information. thanks marc
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.