Some DSPs in a CMM are in recvonly mode - problem?
sess_id conn_id profile stype mode codec pkt vad
33557373 33745937 4 xcode recvonly g711u 20 off
33557373 33745905 4 xcode recvonly g729b 20 off
Here is the first few lines of my show dspfarm connections command. I'm wondering how a DSP gets in recvonly mode and how do I reset or kill the particular session without having to reload the entire CMM? (I have a bunch of T1s that I'd rather not bring down).
Re: Some DSPs in a CMM are in recvonly mode - problem?
The recvonly status is for that particular connection. This is usually not an issue with the DSP hardware. So, resetting will most likely not help.
couple of things to check are:
1. Ip connectivity for the xcode devices. (use the fast ethernet interface, not the gigE). Can you ping the phones or GW, as the case may be?
2. are dsp packets going up in both directions.. tx and rx? If they are not going up in a particular direction, then try to do a "debug mediacard all" to see if there are any problems. A "debug ip rtp pack" might also help - caution, very verbose.
3. Make sure you have the latest version of CMM software. There have been some major fixes in the latest version.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...