Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Splitting a PRI t1

I have a PRI T1 coming to my AS5400. The controller T1 1/0 has the normal setup "pri-group timeslots 1-24"

That creates a Voice port 1/0:0.

What I need are the commands to split those 23 channels in two to be able to have two Voice ports defined.

Any help will be greatly appreciated.

1 ACCEPTED SOLUTION

Accepted Solutions
Blue

Re: Splitting a PRI t1

you cannot split a PRI like you are requesting as you only have one D channel for signaling.

you will only have one voicePort defined for each controller T1 you configure.

5 REPLIES
Blue

Re: Splitting a PRI t1

you cannot split a PRI like you are requesting as you only have one D channel for signaling.

you will only have one voicePort defined for each controller T1 you configure.

Re: Splitting a PRI t1

You can check with AdTrans to see if you can split it. I have in the past, channelized a T1's with AdTrans boxes for data and voice, but not with PRI and PRI.

New Member

Re: Splitting a PRI t1

I like to thank gpulos and tcatlinis for their help.

My problem was solved and I have an alternative.

Again Thank you very much.

Vilaro123

Re: Splitting a PRI t1

Vilaro

Can we ask what the resolution was?

Thanks!

New Member

Re: Splitting a PRI t1

Gpulos explained that I can't do what I wanted because there is only one D channel so it is imposible to split the signaling of the channels.

Not what I would like to hear, but the truth. And you advised on the Adtran equipment and I have an Atlas 500 around here that I will try.

Regards,

Vilaro

117
Views
4
Helpful
5
Replies
CreatePlease to create content