I have several 3750 switch stacks that are connected via 10Mb fibres, I have qos configured on the stacks for VoIP.
I need to configure qos on the 10Mb fibres, these links are set-up as dot1q trunks trunking a couple of vlans one of these vlans is a routed transit vlan.
As the voice vlans are specific to each 3750 switch they are routed accross the 10M. Due to voice recording I am using RSPAN so cannot setup these links as routed links.
Presumabley this means I need to set up layer 2 cos on the switch interface, as all traffic is already marked; can I use the priority queue out command and srr-queuing to specify 3M reserved for the voice traffic?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.