Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SRST: 10 Digits from Telco, 5 digit extensions

I am recieving all 10 digits from Telco, and using the "Significan Digits" field on CCM to only treat the last 5 as significant. This works fine, but when in SRST, incoming calls are rejected due to no matching extensions. Is there a way to ignore the first 5 digits while in SRST?

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: SRST: 10 Digits from Telco, 5 digit extensions

Use the dialplan pattern command underneath call-manager-fallback mode to change from 10 digits to your 5 digit extensions.

http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide_chapter09186a0080153e6c.html

dialplan-pattern tag prefix-pattern extension-length length [no-reg]

This should do the trick for you.

HTH,

Tony

3 REPLIES
Blue

Re: SRST: 10 Digits from Telco, 5 digit extensions

you can use translation rules & profiles to set specific digit translations per dialPeer.

see this link for more info on translation rule configuration: (used for SRST and CME)

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a0080325e8e.shtml

New Member

Re: SRST: 10 Digits from Telco, 5 digit extensions

Greg. Thanks for the input. Here is what I did: As an example, my did is 903-555-1000

dialplan-pattern 1 90355 extension-length 5

So it translate to 51000?

Thanks again,

Robert

Bronze

Re: SRST: 10 Digits from Telco, 5 digit extensions

Use the dialplan pattern command underneath call-manager-fallback mode to change from 10 digits to your 5 digit extensions.

http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide_chapter09186a0080153e6c.html

dialplan-pattern tag prefix-pattern extension-length length [no-reg]

This should do the trick for you.

HTH,

Tony

147
Views
0
Helpful
3
Replies