03-03-2003 12:44 PM - edited 03-12-2019 10:54 PM
Hi,
On the central office I have Cisco 2600, three vg200 with a several FXO and BRI cards. Also, I have one CCM 3.1. Is it possible to implement SRST configuration on 2600 and to use all vg200 for placing and receiving calls in a fall back mode?
Idea is to eliminate need for another server with CCM and to use only a routers.
I already, made SRST on 2600 and this is usefull for inter office calls. But I have problem when I want to place/receive a call to/from the PSTN.
Also, there is no problem when I have GW cards in the SRST enabled router. But problem is when I have GW cards in the separate units such as in VG200.
Any ideas !
Thanks in forward !
You may contact me directly: mladen@mds.co.yu
Mladen
03-04-2003 03:48 AM
Providing you are not using MGCP , then it should be possible to use H323 dial-peers on the Router with a preference command (Higher number) that points to the Vg200.
e.g existing Dial peer to Call Manager
Dial-peer voice 100 voip
destination-pattern .T
session-taget ipv4:10.1.1.1 (Call Manager IP Address)
-----Add new peer pointing to VG200--------
Dial-peer coice 200 voip
destination-pattern .T
preference 2
session-taget ipv4:10.1.1.99 (VG200 IP Address)
03-04-2003 10:39 PM
Thank you. Yesterday, I tested configuration and everything doing fine.
Thanks a lot !!!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide