Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SRST call to BRI interface

I am expierencing problem with placing a call to BRI interface on active srst router. I can place call to all phones registered on srst sctive router, but i can

not place call to bri interface on active srst router. Do i need something to set up?

Martin

2 REPLIES

Re: SRST call to BRI interface

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

Cisco Employee

Re: SRST call to BRI interface

You need to set up dial-peers so that the call can be routed to the BRI. I'm assuming your test is from the IP phones registered to the SRS router. Also, what happens? Does it give you a fast-busy? After how many digits? What do your dial-peers look like on the router?

117
Views
0
Helpful
2
Replies
CreatePlease to create content