07-15-2002 10:08 AM - edited 03-12-2019 07:55 PM
I am expierencing problem with placing a call to BRI interface on active srst router. I can place call to all phones registered on srst sctive router, but i can
not place call to bri interface on active srst router. Do i need something to set up?
Martin
07-21-2002 08:22 PM
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
07-22-2002 06:20 AM
You need to set up dial-peers so that the call can be routed to the BRI. I'm assuming your test is from the IP phones registered to the SRS router. Also, what happens? Does it give you a fast-busy? After how many digits? What do your dial-peers look like on the router?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide