Say I have a remote site and that site goes into SRST mode. I need to setup where if someone at the remote site dials the extension number of someone at the main site how can you prefix the digits automatically so it goes through the PSTN?
Translation rules are probably the best, but you can also add pots dial-peers that match your site codes, and prefix the area code and NXX. As long as they do not overlap with your regular pots dial-peers.
For example if your other site code is 555 which has 212-555-XXXX DIDs, create a pots dial peer with the following parameters:
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...