Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

srst command line check

what ip address need to go here?

for srst config

ip source-address <What address goes here> port 2000 strict-match

Max-dn 50

thanks

  • Other Collaboration Voice and Video Subjects
2 REPLIES

Re: srst command line check

The ethernet interface address of the SRST router.

Hope this helps.

Brandon

Super Bronze

Re: srst command line check

Hi

The address should be the address that the phones will try and register to - i.e. this could be the default gateway by default, or the router interface that you have defined as the SRST reference point.

If you only have one LAN address on your SRST box then that will be it... if it's not the default gateway then you need to set an SRST reference.

Regards

Aaron

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
127
Views
0
Helpful
2
Replies
This widget could not be displayed.