Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
271
Views
0
Helpful
2
Replies

SRST - configuration question

adahan
Level 1
Level 1

‎11-04-2001 06:53 AM - edited ‎03-12-2019 01:10 PM

I'm trying to to configure SRST on C3640, after configuring the "call-manager-fallback" and its parameters, i can see all the new POTS and VOICE-PORTs but i can not configure the ephone-dn and the dial-peer voice 200xx, tried to look on the CCO with no success,am i missing something ? realy appriciate any help.

Labels:
0 Helpful
2 Replies 2

j.ayres
Level 1
Level 1

‎11-04-2001 07:29 AM

There are no dial-peers to configure under SRST for IP Phones.

When the phones lose contact with their CMs they try to register with their default gateway - your SRST router. The router then automatically creates the necessary temporary dial-peers. These do not show up in the configuration but do when you run a show dial-peer voice. They are deleted when the phones re-register with CM.

Hope this helps.

Justin

0 Helpful

adahan
Level 1
Level 1
In response to j.ayres

‎11-04-2001 08:06 AM

Thank you, it is working just fine.

0 Helpful
Customers Also Viewed These Support Documents