Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SRST - configuration question

I'm trying to to configure SRST on C3640, after configuring the "call-manager-fallback" and its parameters, i can see all the new POTS and VOICE-PORTs but i can not configure the ephone-dn and the dial-peer voice 200xx, tried to look on the CCO with no success,am i missing something ? realy appriciate any help.

2 REPLIES
New Member

Re: SRST - configuration question

There are no dial-peers to configure under SRST for IP Phones.

When the phones lose contact with their CMs they try to register with their default gateway - your SRST router. The router then automatically creates the necessary temporary dial-peers. These do not show up in the configuration but do when you run a show dial-peer voice. They are deleted when the phones re-register with CM.

Hope this helps.

Justin

New Member

Re: SRST - configuration question

Thank you, it is working just fine.

110
Views
0
Helpful
2
Replies