I am configuring SRST for the first time. Do I want to put a DHCP scope on the local gateway? I am concerned that the PC's on the local network will get an address from the router and not the DHCP server on the remote side.
You can use either a local DHCP server at the remote site, or configure IOS DHCP server on the router. If you can use a separate vlan (voice vlan) for phones and separate vlan for PCs, you wont have this subnet overlap issue with DHCP.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...