We are configuring a site to have two gateways configured for SRST. We are doing this because of the number of phones located at the site. One of the gateways is a 3640 and the other is a 2620. There are a total of 75 phones. Each phone has at least 2 line appearances. Some of the receptionist phones have sidecars...which can give them 10 or more line appearances. I am controlling the phone registration with access-lists, but I am not able to find a way to control the number of "dial-numbers" (DN's) each phone registers when it goes into fall-back mode. Is there a way I can control this?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...