Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

SRST External Calling Number Mask

Is there a way to mask all outgoing call with the main number on a PRI with a DID block in SRST mode. example Phone 1's external phone number mask is Area code + 7 digit extension say 123 123 1001, extension 2 is 123 123 1002 so on. Main number of business is 123 123 1000, what would be the command/syntax to change the external phone number mask for all calls outbound in SRST mode to main number instead of individual DIDs.

2 REPLIES

Re: SRST External Calling Number Mask

Assuming you have dialplan pattern set, You can setup a translation rule on all outgoing dial-peers.

voice translation-rule 1

rule 1 /1231231.../ /1231231000/

voice translation-profile 1

translate calling 1

dial-peer voice 1 pots

destination-pattern 9T

port 1/0:23

translation-profile outgoing 1

HTH

sankar

PS: please remember to rate posts!

Community Member

Re: SRST External Calling Number Mask

That worked! I was under the impression that there would be commands under the fall-back section, not realizing that standard translation would do the trick. Thx.

716
Views
4
Helpful
2
Replies
CreatePlease to create content