10-08-2006 08:49 PM - edited 03-13-2019 03:16 PM
Is there a way to mask all outgoing call with the main number on a PRI with a DID block in SRST mode. example Phone 1's external phone number mask is Area code + 7 digit extension say 123 123 1001, extension 2 is 123 123 1002 so on. Main number of business is 123 123 1000, what would be the command/syntax to change the external phone number mask for all calls outbound in SRST mode to main number instead of individual DIDs.
10-08-2006 08:55 PM
Assuming you have dialplan pattern set, You can setup a translation rule on all outgoing dial-peers.
voice translation-rule 1
rule 1 /1231231.../ /1231231000/
voice translation-profile 1
translate calling 1
dial-peer voice 1 pots
destination-pattern 9T
port 1/0:23
translation-profile outgoing 1
HTH
sankar
PS: please remember to rate posts!
10-12-2006 07:08 AM
That worked! I was under the impression that there would be commands under the fall-back section, not realizing that standard translation would do the trick. Thx.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: