11-29-2001 12:50 PM - edited 03-12-2019 01:33 PM
CM 3.1(2c), SRST on 2620 with PRI. I followed all the sample configs. Inbound calls work fine. When I try to make an outbound call, I get fast busy after the first digit(no matter what I dial).
Here is config:
dial-peer voice 1 pots
incoming called-number .
destination-pattern 9.
progress_ind progress enable 8
progress_ind connect enable 8
direct-inward-dial
port 1/0:23
call-manager-fallback
ip source-address 10.7.199.3 port 2000
max-ephones 24
max-dn 48
dialplan-pattern 1 630754.... extension-length 4
default-destination 3204
voicemail 5000
Thanks in advance.
11-29-2001 10:57 PM
Hi,
In the Dial-peer pots configuration you should write "destination-pattern 9T" instead of "destination-pattern 9.". Hope it helps.
ERDEM...
11-30-2001 01:01 AM
or try this:
destination-pattern 9
with no dot. you only want the 9 to get the line for you.
11-30-2001 12:33 PM
You must be running IOS 12.1(5YD) code, which does not support PRI with SRST. Upgrade to 12.2.2(XB).
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: