Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

SRST - fast busy on outbound after 1 digit

CM 3.1(2c), SRST on 2620 with PRI. I followed all the sample configs. Inbound calls work fine. When I try to make an outbound call, I get fast busy after the first digit(no matter what I dial).

Here is config:

dial-peer voice 1 pots

incoming called-number .

destination-pattern 9.

progress_ind progress enable 8

progress_ind connect enable 8

direct-inward-dial

port 1/0:23

call-manager-fallback

ip source-address 10.7.199.3 port 2000

max-ephones 24

max-dn 48

dialplan-pattern 1 630754.... extension-length 4

default-destination 3204

voicemail 5000

Thanks in advance.

3 REPLIES
Community Member

Re: SRST - fast busy on outbound after 1 digit

Hi,

In the Dial-peer pots configuration you should write "destination-pattern 9T" instead of "destination-pattern 9.". Hope it helps.

ERDEM...

Community Member

Re: SRST - fast busy on outbound after 1 digit

or try this:

destination-pattern 9

with no dot. you only want the 9 to get the line for you.

Community Member

Re: SRST - fast busy on outbound after 1 digit

You must be running IOS 12.1(5YD) code, which does not support PRI with SRST. Upgrade to 12.2.2(XB).

511
Views
0
Helpful
3
Replies
CreatePlease to create content