Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SRST / H.323 on FXO

I am using a 2811 router with 6 fxo ports configued as h.323 gateway with call manager 4.0(2). I have configured the SRST for failover. During SRST I can have only two incoming calls.

Is there anyway to define more than two calls.

The below is my config..

call-manager-fallback

secondary-dialtone 9

max-conferences 1 gain -6

transfer-system full-consult

limit-dn 7940 2

limit-dn 7960 6

timeouts interdigit 3

ip source-address 10.1.84.254 port 2000

max-ephones 24

max-dn 128

transfer-pattern 25...

keepalive 10

default-destination 25325

alias 1 T to 25325

call-forward busy 25310

My requirement is like , lets during SRST line 1 connects to extension 25000 , line 2 to 25001 , line 3 to 25002 etc...

2 REPLIES
Green

Re: SRST / H.323 on FXO

Normally with MGCP that is accomplished with PLARs to each DN under voiceports.

But since this is H.323 I would like to check other configuration that might overlaps and will show why you are getting only 2 calls.

Check out this link:

http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_administration_guide_chapter09186a0080392682.html#wp1348729

HTH

Gonzalo

New Member

Re: SRST / H.323 on FXO

Thanks , but the attched docu. doesn't provide much informations..

I have configure this in lot of places using MGCP , but in H.323 I am facing this issue. Customer has got 6 FXO lines and he need that during SRST he should be able to get 6 incoming calls.

Thanks.

179
Views
0
Helpful
2
Replies
CreatePlease login to create content