Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

SRST Help!!

I am in SRST mode and cannot gain access to the PRI.

I am able to dial to the numbes associated with the PRI

I have the following commands in the fallback config:

access-code pri 9 direct-inward-dial

secondary-dialtone 9

Also, incoming calls

1 REPLY
New Member

Re: SRST Help!!

You need to create a dial peer to direct calls to your PRI such as ...

dial-peer voice 10 pots

destination-pattern 9[2-9]......

port 0/0/0:23 ***use your voice port***

forward-digits 7

You should build a dial peer for each dial pattern available in your area. Post a config and your location if you need more help.

128
Views
0
Helpful
1
Replies
CreatePlease to create content