Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

SRST implementation using MGCP or H323

4 REPLIES
Bronze

Re: SRST implementation using MGCP or H323

SRST uses H.323

Ken

Community Member

Re: SRST implementation using MGCP or H323

if i want to use dial peer for routing call when WAN failoure do i need H323 configuration or MGCP (MGCP call fallback and application default ,alteran app)?

Community Member

Re: SRST implementation using MGCP or H323

To start you will need to have at least something to this effect on a MGCP gateway:

General SRST GUIDELINES - Basic

application

global

service alternate Default

ccm-manager fallback-mgcp

dial-peer voice 1 pots

preference 1

service mgcpapp

destination-pattern 9T

progress_ind setup enable 3

incoming called-number .

direct-inward-dial

port 0/0/1:23

!

!

!

call-manager-fallback

secondary-dialtone 9

max-conferences 8 gain -6

transfer-system full-consult

limit-dn 7940 2

limit-dn 7960 4

ip source-address (Gateway IP Address)port 2000

max-ephones XX

max-dn xxx dual-line preference 1

system message primary Phone System Fallback

voicemail XXXXXXXXXX

This is just a start and you will need to customize it to fit your environment. But this will at least get you started....

Community Member

Re: SRST implementation using MGCP or H323

thank you very much for your assistance.but i used H323 only So can H323 configurations to be sufficient for SRST to work as Expected without MGCP configuration

392
Views
0
Helpful
4
Replies
CreatePlease to create content