08-28-2006 04:42 AM - edited 03-13-2019 02:46 PM
08-28-2006 05:17 AM
SRST uses H.323
Ken
08-28-2006 05:37 AM
if i want to use dial peer for routing call when WAN failoure do i need H323 configuration or MGCP (MGCP call fallback and application default ,alteran app)?
08-28-2006 07:33 AM
To start you will need to have at least something to this effect on a MGCP gateway:
General SRST GUIDELINES - Basic
application
global
service alternate Default
ccm-manager fallback-mgcp
dial-peer voice 1 pots
preference 1
service mgcpapp
destination-pattern 9T
progress_ind setup enable 3
incoming called-number .
direct-inward-dial
port 0/0/1:23
!
!
!
call-manager-fallback
secondary-dialtone 9
max-conferences 8 gain -6
transfer-system full-consult
limit-dn 7940 2
limit-dn 7960 4
ip source-address (Gateway IP Address)port 2000
max-ephones XX
max-dn xxx dual-line preference 1
system message primary Phone System Fallback
voicemail XXXXXXXXXX
This is just a start and you will need to customize it to fit your environment. But this will at least get you started....
09-04-2006 11:05 PM
thank you very much for your assistance.but i used H323 only So can H323 configurations to be sufficient for SRST to work as Expected without MGCP configuration
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: