When we configure in CallManager we give the line text label for all the phones. In the SRST mode all the phones displays the number instead of name. Is there any way we can confiugre the line text labels instread of numbers in SRST.
With CME 4.0, you can run srst-mode and give the phones under srst-mode, CME like features. YOu can pre-provision the ephones and ephone-dns prior to failover. Since you are using CME, you should be able to use label command under each ephone-dn to configure the line text label.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...