I have been searching but unable to find this answer.
1) How do you get the .wav file onto the flash device of the remote router? I?m guessing use tftp?
2) I read in the ?Integrating Cisco CallManager and Cisco SRST to Use Cisco SRST as a Multicast MOH Resource? guide that it will make 4 copies of the file on the router?
My main concern is the available flash on the router. The moh file that we are using is large. I pulled the XXXX.MULAW.WAV file from the publisher in location c:\program files\cisco\moh ? the file is 6,705KB. I?m concerned about the size once on the router and especially if the router will make more than one copy of the file.
Re: srst moh - my main concern is the available flash
Also, you can easily drag and drop the file into the flash card, if you have a flash card reader (costs you 10-20$ from Frys or Bestbuy)..Make sure you dont format the card in your PC. This will again work only in case of 2800s or 3800s.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.