Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SRST MOH

Hi,

We have a 2651 XM router with STST 3.2 configured on it.There is no PSTN link terminated on the router.IP phones at branch office will rehome to SRST router when link to CCM 4.1(3) is down.

Problem - MOH on the SRST router is not working.

I have given the command moh <file name> in the call-manager fall-back.

file(default moh file on CCM) type is u-law.

When I press hold on an IP phone registered to SRST router,the other end(IP phone registered to same SRST router) hears just a beep.

Both the phones are connected to same switch.

Is there anything else to be configured.

Regds

KMS

1 REPLY

Re: SRST MOH

MOH in SRST mode works only for G.711 VoIP and PSTN calls, A tone is heard for calls between internal phones. See the following link for confirmation.

http://www.cisco.com/en/US/products/sw/iosswrel/ps5012/products_configuration_guide_chapter09186a0080181322.html#wp1338028

Hope this helps. If so, please rate the post.

Brandon

141
Views
5
Helpful
1
Replies