Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SRST not Test OK

My scenario:

We have a CCM cluster on city A and a router 2811 on city B, the call processing is OK, but the SRST Test not.

When We apply ( disconnect ) fail over to simulate SRST mode:

1.- Call over T1 go 120 IPM

2.- The POE switch send traffic over wan

3.- The call Manager not certify the secure SRST, retur error

Thank,

Juan

5 REPLIES
Hall of Fame Super Silver

Re: SRST not Test OK

Please post your SRST router config.

Chris

New Member

Re: SRST not Test OK

Check attach

Re: SRST not Test OK

Juan,

Your Secure SRST config is not complete. I would suggest you to get regular SRST working properly prior to configuring Secure SRST. (One step at a time).

New Member

Re: SRST not Test OK

Sir,

Can you refresh me the step?

So I need to run a check list to verify

Thank

Juan

Re: SRST not Test OK

Here is a non-secure SRST sample config. You may not need all of it. This is just something thats running in lab..

call-manager-fallback

secondary-dialtone 9

max-conferences 1 gain -6

transfer-system full-consult

timeouts interdigit 7

ip source-address 10.5.201.1 port 2000

max-ephones 3

max-dn 6 dual-line

dialplan-pattern 1 6175222... extension-length 4

transfer-pattern .T

keepalive 20

voicemail 912122221600

call-forward pattern .T

call-forward busy 912122221600

call-forward noan 912122221600 timeout 12

moh SampleAudioSource.ulaw.wav

dial-peer voice 1 pots

incoming called-number .

direct-inward-dial

port 0/0/1:23

!

dial-peer voice 2 pots

destination-pattern 911

port 0/0/1:23

forward-digits all

!

dial-peer voice 3 pots

destination-pattern 9[2-9]......

port 0/0/1:23

forward-digits 7

!

dial-peer voice 4 pots

destination-pattern 91[2-9]..[2-9]......

port 0/0/1:23

forward-digits 11

!

dial-peer voice 5 pots

destination-pattern 9011T

port 0/0/1:23

prefix 011

To add Secure SRST into this picture, you need a CA server (can configure your SRST router to be the SA) For this you need Advanced IP services or better feature set to support both voice and encryption. Here is a good link to start with for Secure SRST.

http://www.cisco.com/univercd/cc/td/doc/product/voice/srst/srst33/srst33ad/index.htm

In the link, check the section Setting up Secure SRST

HTH

sankar

PS: please remember to rate posts!

218
Views
4
Helpful
5
Replies