Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

SRST not using the prefix command during failover

I have a 2610 running YD3 code, during failover, the prefix command is not prepending any digits into the call and the call fails. Duuring normal operation the prefix command works fine. I was running YD2 but Cisco TAC told me this is fixed with YD3 and it still does not work. Any ideas?

1 REPLY
Community Member

Re: SRST not using the prefix command during failover

hi,

I use YD3 on a 3600 router and i do not have such problems. Are you sure the call matches the correct pots dial-peer?

Yanna

121
Views
0
Helpful
1
Replies
CreatePlease to create content