Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SRST Outbound PRI

I am in SRST mode and cannot gain access to the PRI.

I am able to dial to the numbes associated with the PRI

I have the following commands in the fallback config:

access-code pri 9 direct-inward-dial

secondary-dialtone 9

Dial-peer voice 20 pots

destination-pattern 9T

incoming called-number

direct-inward-dial

port x/x/x

Also, incoming calls work fine.

2 REPLIES
New Member

Re: SRST Outbound PRI

I suggest that you run the debug voice dialpeer command to see what's happening. I suspect you may need to have an outgoing profile associated with the dialpeer, that's what the debug indicated to me and when I created the profile I could then dial out in SRST mode for both PRI and BRI

Here's the relevant entries;

voice translation-rule 2

rule 1 /^1/ // type any unknown

voice translation-profile OutBound

translate called 2

dial-peer voice 11 pots

translate-profile outgoing OutBound

destination-pattern 1T

direct-inward-dial

preference 1

port 0/0/1

call-manager-fallback

transfer-pattern 1T

transfer-pattern 64..

secondary-dialtone 1

I don't have the access-code line on my config

Let me know if you still have no luck and I'll dump down the entire config for you to have a look at.

Good luck,

John

New Member

Re: SRST Outbound PRI

I will give it a try. Thanks for posting.

190
Views
0
Helpful
2
Replies
CreatePlease login to create content