Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SRSt over multiple VG200 gateways at a remote site

Could someone please help me with some configuration assistance. I know how to configure SRSt on a router that is loaded with voice cards no problem. I can make and receive call just fine that way. However, at a remote site, we have 1 router and 3 Vg200 gateways. The Vg's have the FXO voice cards in it, the router does NOT have any voice cards. When I pull the T1 line to force Fallback, I cannot get any calls to route out the VG200 gateways PSTN trunks. I've tried about every combination of dial peers I could think of. On each side, the router and the gateways. I also turned debug on. The gateway(s), never even see the attempted call. Can someone please tell me if this scenario is supported??? I only see configuration on Cisco's website for the voice cards in the router method. I really need to get this to work for the VG200's though.

Thanks for any help.

Tim Petersen

  • Other Collaboration Voice and Video Subjects
1 REPLY

Re: SRSt over multiple VG200 gateways at a remote site

Often times complex configuration/troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

102
Views
0
Helpful
1
Replies
This widget could not be displayed.