Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SRST problem for outside access

I've a CCM with IP-phones and a SRST gateway (3620) with PRI E1 access to th PSTN.

To access the PSTN a 0 is dialed in front of the called number and on the CCM I use the PreDot to remove this 0 before I send the number to the 3620.

On the 3620 I've a dial-peer pots with destination pattern 'T'.

No problem here.

Now when the CCM goes down and the SRST takes over you can not dial the PSTN numbers anymore with the 0-accesscode. But you need to remove this access code and then it works. Is there a sub-command under Call-manager-fallback which removes this leading 0 for me, so that I have full transparency?

Is the command 'access-code' doing this?

2 REPLIES
Cisco Employee

Re: SRST problem for outside access

Try using access-code pri 0. You will probably need to use the latest 12.1(5)YD image or 12.2(2)XB image for this to work.

New Member

Re: SRST problem for outside access

I've tried with the access-code command but it does not work. The image I was working with was: 12.1(5)YD4. So 12.2(2)XB also supports SRST?

110
Views
0
Helpful
2
Replies