1. Go to Callmanager - Service - Service Parameters. Choose the CM and Cisco Callmanager service. Change the parameter "Station Keepalive Interval". Default is 30 s, you can change it to as low as 10. Just a side note, that reducing KA can cause lot more traffic on the network (more frequently)
2. I think your dial-peers are matching T pattern which waits 10 secs after the last digit you dial, before sending the digits to PSTN. YOu can change it using timeout interdigits command under call-manager-fallback mode.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4