I'm testing SRST and have run into one problem - when my wan fails SRST takes over fine. But when my wan comes back up and the phones homes back to my callmanager, they come back to a normal appearance but are "locked up". They will ring but can not be answered, and can not place calls from it. I reset the phone and they are fine again. Any tips?
This was an issue in the SRST code running on the router. Upgrade to the latest 12.2(11)T code and retest. If issue persists, please take a sniffer trace of this happening from the back of the phone and open a TAC case. /Wes
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...