12-02-2003 01:53 PM - edited 03-13-2019 02:49 AM
How I must configure a E1 controller of a 5300 to interconet to a SS7 switch ???
is with ds0-group and with type p7 ??
or pri-group ?
I don't find any example config for SS7 interconection, only for R2 or ISDN.
TIA
Solved! Go to Solution.
12-03-2003 03:05 AM
Only way to terminate SS7 to an As5300 is to use an external PGW 2200 SS7 controller. You can't connect and process the SS7 signalling traffic directly on the AS5300 gateway.
You can use a AS5350 or AS5400 as an integrated SLT. Here is more information -
http://www.cisco.com/warp/public/cc/pd/ga/2200pstn/prodlit/pg220_qp.htm
http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120limit/120xr/0219nomd.htm
Setting up a SS7 interconnect is a complex undertaking. You might want to do some research on the Cisco web site using the keywords 'PGW2200' 'VSC' 'SLT'
12-03-2003 03:05 AM
Only way to terminate SS7 to an As5300 is to use an external PGW 2200 SS7 controller. You can't connect and process the SS7 signalling traffic directly on the AS5300 gateway.
You can use a AS5350 or AS5400 as an integrated SLT. Here is more information -
http://www.cisco.com/warp/public/cc/pd/ga/2200pstn/prodlit/pg220_qp.htm
http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120limit/120xr/0219nomd.htm
Setting up a SS7 interconnect is a complex undertaking. You might want to do some research on the Cisco web site using the keywords 'PGW2200' 'VSC' 'SLT'
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: