Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

SS7 E1 Config in 5300 GW

How I must configure a E1 controller of a 5300 to interconet to a SS7 switch ???

is with ds0-group and with type p7 ??

or pri-group ?

I don't find any example config for SS7 interconection, only for R2 or ISDN.

TIA

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: SS7 E1 Config in 5300 GW

Only way to terminate SS7 to an As5300 is to use an external PGW 2200 SS7 controller. You can't connect and process the SS7 signalling traffic directly on the AS5300 gateway.

You can use a AS5350 or AS5400 as an integrated SLT. Here is more information -

http://www.cisco.com/warp/public/cc/pd/ga/2200pstn/prodlit/pg220_qp.htm

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120limit/120xr/0219nomd.htm

Setting up a SS7 interconnect is a complex undertaking. You might want to do some research on the Cisco web site using the keywords 'PGW2200' 'VSC' 'SLT'

1 REPLY
Silver

Re: SS7 E1 Config in 5300 GW

Only way to terminate SS7 to an As5300 is to use an external PGW 2200 SS7 controller. You can't connect and process the SS7 signalling traffic directly on the AS5300 gateway.

You can use a AS5350 or AS5400 as an integrated SLT. Here is more information -

http://www.cisco.com/warp/public/cc/pd/ga/2200pstn/prodlit/pg220_qp.htm

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120limit/120xr/0219nomd.htm

Setting up a SS7 interconnect is a complex undertaking. You might want to do some research on the Cisco web site using the keywords 'PGW2200' 'VSC' 'SLT'

496
Views
0
Helpful
1
Replies
CreatePlease to create content