Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

static noise on outbound calls from CME 4.0.

I have CME 4.0 on a 2801 with 12.4(4)XC ipvoice and 7 channels of a T1 ISDN PRI on an mft card. On my 7970 phones, which are running the latest code, when I make outbound calls to the PSTN I hear a short lived static sound usually during the beginning of the call, but often at intervals during a conversation. I have searched this forum but cannot seem to find anyone with a similiar issue. I have included relevant portions of my config. Recommendations welcome:

network-clock-participate wic 1

network-clock-select 1 T1 0/1/0

isdn switch-type primary-ni

controller T1 0/1/0

framing esf

linecode b8zs

pri-group timeslots 1-7,24

interface Serial0/1/0:23

no ip address

encapsulation hdlc

isdn switch-type primary-ni

isdn incoming-voice voice

isdn supp-service name calling

no cdp enable

dial-peer voice 5 pots

description ** T1 PRI pots dial-peer **

destination-pattern 9911

port 0/1/0:23

forward-digits 3

!

dial-peer voice 6 pots

description ** T1 PRI pots dial-peer **

destination-pattern 9T

port 0/1/0:23

!

dial-peer voice 7 pots

description ** T1 PRI pots dial-peer **

incoming called-number .

direct-inward-dial

port 0/1/0:23

voice-port 0/1/0:23

Thanks in advance,

Tony

  • Other Collaboration Voice and Video Subjects
2 REPLIES
New Member

Re: static noise on outbound calls from CME 4.0.

I do not dee your DSP resources and I thought you can not do voice on a 2801 the processor power is too weak. I have seen this issue in FXO ports and the DSP was bad also use a T train IOS 12.4(3b) is also a good one.

473
Views
0
Helpful
2
Replies