Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Stiver in Callmanager 3.3

In CM 3.2 I could use C:\Sti\stiver.exe to get information on what OS version, service packs, etc. were installed. In CM 3.32 there is no Sti folder, so it appears that this utility is gone. How do I get this information in 3.32?

Thank you.

2 REPLIES
New Member

Re: Stiver in Callmanager 3.3

You could use c:\utils\mcsver.exe instead.

Cisco Employee

Re: Stiver in Callmanager 3.3

Just an additional note here:

Any server that was installed fresh using the OS CDs version 2000.2.4 or later will have ONLY the utility located at C:\Utils\MCSVer.exe

Any server that was installed fresh using the OS CDs anything earlier than the above, and then later upgraded to 2000.2.4 will have C:\Utils\MCSVer.exe and also C:\STI\STIVER.exe.

Both utilities are valid. Just keep in mind you should start remembering to use MCSVer.exe all the time for servers running 2000.2.4 or later.

115
Views
0
Helpful
2
Replies