Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

STUN SERVER SETTING CISCO 7940

Okay I finally got this 7940 set up, but from what I can tell I need to be able to set it up to use a stun server for the gizmo SIP phone service. I ran wireshark and made calls with the gizmo software and it deffinately uses stun. I have the newest firmware I could find on the phone and no stun settings, are you just not supposed to use stun with these phones? my firmware settings are

Application Load ID

P03-08-6-00

Boot Load ID

PC030301

DSP Load ID

4.0(2.0)[A0]

am I just hosed?

1 REPLY
Hall of Fame Super Gold

Re: STUN SERVER SETTING CISCO 7940

Sorry, cisco phones don't support stun.

What you can do, is to configure nat_enable and nat_address ip in the config file. look at:

http://www.voip-info.org/wiki/view/cisco+mass+deployment

hope this helps, please rate post if it does!

2528
Views
0
Helpful
1
Replies