Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Hall of Fame Super Gold

Suppressing sending complete IE in SETUP

I have a situation in which a call comes in via h323 with enbloc dialing. I have no direct control on the originating GW.

Calls is routed to BRI pots, but because of the above, sending complete IE is sent in setup and call fails. I wanted the audio to cut-trough and dial DTMF.

Is there a way to suppress Sending Complete IE in thse calls ?

2 REPLIES
Green

Re: Suppressing sending complete IE in SETUP

Hall of Fame Super Gold

Re: Suppressing sending complete IE in SETUP

Hi, I should have mentioned that

no isdn sending-complete

has no effect, and is the default anyway.

I understand it is used for data calls only.

153
Views
0
Helpful
2
Replies