Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

ali
New Member

Symbol Access Point

I currently received a Symbol Access Point (Model NumberAP-4111 H-version A) to integrate into our existing AVVID network. When I make a call from the MU to an IP phone, I can hear the receiving end but they cannot hear me.

Please advise if you experienced this before.

PS- Everything on the same VLAN

Thanks,

2 REPLIES
New Member

Re: Symbol Access Point

Do you know if Symbol’s access point is voice compatible? Can it identify and prioritize voice packets? Is it half or full duplex?

New Member

Re: Symbol Access Point

Nice to met you . We also use Symbol AP-2414-1BZL and

FHSS wireless phone to communication each other . We

found it unworkable if setting of G.729 Codec . The Vendor told me that it supported for G.711 & G.729 .

It only workable of G.711 equipment .

Call will be disconnected after pick up .That's means

Codec problem . Maybe useful for you .

Ps.We also build H/W Transcoder .

Thanks

244
Views
0
Helpful
2
Replies