T1 CAS & MGCP

[droessler]

I am running ICS7750, CCM3.1.2c, with MRP200 and T1 CAS connected. IOS Version: 12.2(4)XL1, EARLY DEPLOYMENT. Currently the gateway is H323, however I want to run MGCP.

Can I with this setup? If not what IOS and CCM do I need to be at in order to run MGCP on MRP200 w/ T1 CAS...

Thanks,

[gillins]

122-11.T.bin should work for you.

after you set up the gateway in cm you will need to add a few commands to the gateway.

1. get rid of all dial peer or save them if you ahve to go back.

2.config mode

3.ccm-manager mgcp

4.ccm-manager config server xxx.xxx.xxx.xxx

5.ccm-manager config

this should get you going. a simple search on the tac web site should provide a lot of information.