Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

T1 CAS on 6608 T1 blade

Is this supported yet in Call Manager? I have heard that it is supported but I have not found anyone that has configured it successfully nor have i found any supporting documentation. If it does support T1 CAS, does it support all the protocols? e&m immediate/wink etc....

Thanks!

1 REPLY
Cisco Employee

Re: T1 CAS on 6608 T1 blade

This will be supported in CallManager 3.1 which is still a few months out. It doesn't support all the protocols. I know it will do wink-start and delay-dial, it will not do immediate-start is what I have found although I don't know that's final. I was originally told that it would not do loop-start channels but I think that has changed as well. But it will definitely do wink-start as I said which is the most common T1 CAS signaling type in our experience.

117
Views
0
Helpful
1
Replies