T302 Timer

[rsadelski]

CUCM 7.x We are planning on increasing out T302 timer and we were wondering does that require a reset of the callmanager service in Cisco unified serviceabillity.  We tested it on our lab ccm without resetting the cm service and the t302 change took.  But some blogs say to restart the cm service.   

[Jaime Valencia · Accepted solution]

You don't need to restart services for the change to work

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

[rsadelski]

Do you have to make the change in all the servers or if you make the change on the pub will it replicate it to the subs.

Thanks

[Jaime Valencia · Accepted solution]

That is clusterwide as noted in the config settings it's under:

Clusterwide Parameters (Device - General)

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk