Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

T302 Timer

CUCM 7.x We are planning on increasing out T302 timer and we were wondering does that require a reset of the callmanager service in Cisco unified serviceabillity.  We tested it on our lab ccm without resetting the cm service and the t302 change took.  But some blogs say to restart the cm service.   

2 ACCEPTED SOLUTIONS

Accepted Solutions
Cisco Employee

Re: T302 Timer

You don't need to restart services for the change to work


HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
Cisco Employee

Re: T302 Timer

That is clusterwide as noted in the config settings it's under:

Clusterwide Parameters (Device - General)


HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
3 REPLIES
Cisco Employee

Re: T302 Timer

You don't need to restart services for the change to work


HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: T302 Timer

Do you have to make the change in all the servers or if you make the change on the pub will it replicate it to the subs.

Thanks

Cisco Employee

Re: T302 Timer

That is clusterwide as noted in the config settings it's under:

Clusterwide Parameters (Device - General)


HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
3356
Views
0
Helpful
3
Replies