I have a 3rd party voicemail that will accept voice/fax calls connected to a SIP trunk on CCM5. My gateway is a different SIP trunk on CCM5. Inbound calls that are CFNA to vm work just fine. The problem is the T38 fax. I can't get the fax to pickup - does anyone know what is needed to get CM5 to allow T38 faxes to come in one SIP trunk and out another SIP trunk? FYI - I know the gateway/vm setup is fine - if a change the dial-peer target to the IP of the vm server, T38 works prefectly. Any ideas?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...