Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

TAPS - Multiple Appearance DNs

Is there any way that TAPS can be used to add phones that have Multiple Appearance Directory numbers?

Thanks!

Steve

1 REPLY
Hall of Fame Super Red

Re: TAPS - Multiple Appearance DNs

Hi Steve,

According to this TAPS doc, this is supported. Have a look;

Configuration Tip

If you are planning to use TAPS to configure shared-line phones, you must create a unique external phone number mask for each shared-line phone.

From this doc for TAPS 5.0(1);

http://www.cisco.com/en/US/products/sw/voicesw/ps556/prod_release_note09186a00801e87a5.html#wp1717634

Hope this helps!

Rob

Please remember to rate helpful posts.....

158
Views
5
Helpful
1
Replies
CreatePlease to create content